Powkiddy RGB10 Max 3 Pro¶
Overview¶
| Device | CPU / Architecture | Kernel | GL driver | Interface |
|---|---|---|---|---|
| RGB10 Max 3 Pro | Amlogic A311D / Mali G52 M4 (ARMv8-A) | Mainline Linux | Mali | Weston + Emulation Station |
Features¶
| Feature | Notes |
|---|---|
| Storage | JELOS should be installed directly to the internal EMMC. When installed directly to the EMMC; an SD Card can be used for game storage. |
| Wifi | Can be turned on in Emulation Station under Main Menu > Network Settings |
| Bluetooth | Supports bluetooth audio and controllers |
Notes¶
Installation¶
Download the latest S922X-Odroid_GOU version of JELOS from the button below.
!!! note "JELOS must be flashed directly onto the RGB10 Max 3 Pro rather than an SD card. This is done by putting the device into recovery mode, per the manual by holding down R2, L2, and power. A video demonstation is shown here.
Troubleshooting¶
You cannot brick this device. If you cannot get into recovery mode, do the following:
- Download this recovery image.
- Flash the image to a spare microSD card using Balena Etcher or similar.
- Remove the back cover of the device (four screws).
- Locate a small button on the back of the board (the side that's visible), near the right thumbstick.
- While holding down the small button, power on the device.
The device should now be in recovery mode, ready to flash JELOS (or other firmware) to the device.
If you find yourself doing this often, consider drilling a pinhole in the back cover so that the button can be accessed with a paperclip.
